我有一个关于在Fortran 90的模块中使用子例程的问题。这是我的代码
Module Multiplication
Subroutine Two_times(input,output)
Real :: input,output
output = input * 2.0
End Subroutine Two_times
End Module
Program test_get_command_argument
Use Multiplication: Two_times
Real :: i,j
i = 0.5
Write (*,*) i
Call Two_times(i,j)
Write (*,*) j
End Program
我用ifort编译上面的代码。我收到以下消息。
files_rev.f90(2): error #6218: This statement is positioned incorrectly and/or has syntax errors.
Subroutine Two_times(input,output)
--^
files_rev.f90(4): error #6274: This statement must not appear in the specification part of a module.
output = input * 2.0
----^
files_rev.f90(5): error #6786: This is an invalid statement; an END [MODULE] statement is required.
End Subroutine Two_times
--^
files_rev.f90(5): error #6785: This name does not match the unit name. [TWO_TIMES]
End Subroutine Two_times
-----------------^
files_rev.f90(6): error #6790: This is an invalid statement; an END [PROGRAM] statement is required.
End Module
^
files_rev.f90(9): error #5082: Syntax error, found IDENTIFIER 'MULTIPLICATION' when expecting one of: ( : % [ . = =>
Use Multiplication: Two_times
------^
files_rev.f90(8): warning #5427: Program may contain only one main entry routine
Program test_get_command_argument
--------^
compilation aborted for files_rev.f90 (code 1)
为什么我收到＃6218和＃6274错误消息以及如何解决它们？
您contains在subroutine声明之前缺少关键字，在only之后缺少关键字use。或者，您可以删除: Two_times以使用模块中的所有内容。因此，工作代码如下所示：
Module Multiplication
Contains
Subroutine Two_times(input,output)
Real :: input,output
output = input * 2.0
End Subroutine Two_times
End Module
Program test_get_command_argument
Use Multiplication, Only: Two_times
Real :: i,j
i = 0.5
Write (*,*) i
Call Two_times(i,j)
Write (*,*) j
End Program
本文收集自互联网，转载请注明来源。
如有侵权，请联系 [email protected] 删除。
我来说两句